On 10/10/2008, shigella Gazeta.pl <[EMAIL PROTECTED]> wrote: > Hello, > According to suggestions in manual I run Jmeter from command line. > I couldn't find way to write final results of Aggregate Report in logs. > These results are visible only from GUI. > I "resolved" problem using data from stdout and I parse it to get clean > result, but it data are not the same in GUI listener and in stdout. > I have also to cut "mid-results" manually because Jmeter sometimes writes > summary for i.e. 4598, 5683 and all samples. I need only results for all he > samples. > Is that possible to show in log results for Aggregate Report?
No, but you can press the "Save Table Data" button at the end of a GUI test run and it will save the data. BTW, the Summary Report uses less memory if you don't need median and 90%. If you need the data from a non-GUI run, then either process the data file using some other tool, or load the file in again and press the button. This has been discussed recently on the mailing list. > Thanks > > Shigella > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
