Use a send to the bus. Then on the bus itself, autmate the volume, turning it up when you want reverb, and turning it down when you don't. Use automation snapshots to do this. Arm the volume controll for automation, set the value you want at the part of the project you want, then take a snapshot. Then move to the other part say where you want it to stop, make the volume of the bus -inf, and set another snapshot etc.
HTH, D!J!X! -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Christian Sent: Monday, November 08, 2010 7:11 PM To: [email protected] Subject: [Jsonar] More on automation Hi all, OK, so I suppose I don't do everything right here but here is what I try to do: I have a project which I explained in another mesasge and i want to add some effects to it in the later part of it and mute them later on and that could be done wiht automation. I first tried adding a bus with the Lexicon pantheon reverb and I set all parameters, but I am not able to set an automation snapshot where I want it to start and I don't want to place the effect on the audio track itself. What am I doing wrong here? Many thanks, Christian _______________________________________________ Find JSonar and Sonar FAQs, articles, guides and downloads at jsonar.org. Jsonar mailing list [email protected] http://jsonar.org/mailman/listinfo/jsonar_jsonar.org _______________________________________________ Find JSonar and Sonar FAQs, articles, guides and downloads at jsonar.org. Jsonar mailing list [email protected] http://jsonar.org/mailman/listinfo/jsonar_jsonar.org
