Hi Damien, I am using M7i with JunOS 6.3 I put the filter on the interface section, and yes, i am having several VRF and connected to other sites using mpls with rsvp signaling.
-rendo- On 3/1/07, Damien Holloway <[EMAIL PROTECTED]> wrote: > > Mpls packets are switched through without inspecting the content in a vpn > environment. > There are a couple of solutions depending on your hardware and software > and configuration. > What hardwarw do you have ? > What software version? > Are you deploying vpn's? And doing this within a vrf? > > Regards > > Damien > > ___________________________ > Damien Holloway > Senior Instructor / Proctor > Juniper Networks Hong Kong > ICBC Tower > Citibank Plaza, 3 Garden Road > SUITES 2507-11, 25/F > Central Hong Kong > +852 6793 0450 mobile > +852 2574 7803 fax > [EMAIL PROTECTED] > www.juniper.net > ___________________________ > > > > -----Original Message----- > From: [EMAIL PROTECTED] < > [EMAIL PROTECTED]> > To: juniper-nsp@puck.nether.net <juniper-nsp@puck.nether.net> > Sent: Thu Mar 01 11:37:14 2007 > Subject: [j-nsp] firewall filter > > Hi, > > I have a problem with firewall filter and MPLS. > > My target is to block specific source traffic towards the host on the > other > end of ATM interface, so I put an output filter in an ATM interface. > > what i got about any specific packet that i want to discard are: > - any packet from another ATM interface as well as any other external > traffic is filtered > but > - packet coming from mpls is NOT filtered at all > > Since i run mpls also in the same router, Is it a normal behaviour? do i > need to put the filter in forwarding table to filter the traffic from > mpls? > > thanks. > > -rendo- > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp