output-vlan-map { swap; }
will do the trick ...... Also ignore STP packets on ce1, ce2 eth interfaces if in switch mode.... Krasi ------------------------------------------------------------------------ ---Original Message---------------------------------- FROM: [EMAIL PROTECTED] TO: [EMAIL PROTECTED] SUBJECT: Re: Re: [j-nsp] VPLS with 2 interfaces on the same router SENT: APRIL 17, 2007 04:21PM CC: juniper-nsp@puck.nether.net -------------------------------------------------------- > my question is - that is wrong in my configuration, so VPLS not work(I can't > ping CE1 CE2). > I use cisco routers like CE, and see with 'show cdp neighbors' myself - on > CE1 I see CE1 like neighbor and also on CE2 I see CE2. > I do not configure any in BGP section, or > some other section except that I write before. > Also may be I must configure some input-vlan-map and output-vlan-map on my > subinterfaces to join its in the same VPLS instance? > > > As I write before I use 1x G/E IQ on my m7i: > show chassis hardware > Hardware inventory: > Item Version Part number Serial number Description > Chassis A1674 M7i > Midplane REV 04 710-008761 CS5290 M7i Midplane > Power Supply 0 Rev 02 740-008985 6081743 DC Power Supply > Power Supply 1 Rev 02 740-008985 6081742 DC Power Supply > Routing Engine REV 10 740-009459 1000627040 RE-5.0 > CFEB REV 08 750-010464 CN9963 Internet Processor II > FPC 0 E-FPC > PIC 0 REV 09 750-003873 CP9902 4x E1, RJ48 > PIC 1 REV 09 750-007641 CR6244 1x G/E IQ, 1000 BASE > Xcvr 0 NON-JNPR PT6406943 SFP-LX > FPC 1 E-FPC > PIC 2 REV 07 750-009487 CM8139 ASP - Integrated (Layer-2-3) > PIC 3 REV 08 750-009099 CS2332 1x G/E, 1000 BASE > > > Can you provide some real working examples? > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp