This is a very strange question, and very strange scenario... but I'm also getting some very strange errors, so I'm hoping that someone here may have seen this before and can give me some hint of whatever I'm apparantly not thinking of! I have a GRE tunnel from a J2300 to a Cisco router. The GRE is very simple, and it works just fine (at least as far as pinging the other end of the tunnel or telnetting to it goes!). However, BGP over this tunnel does not work. Again, it SHOULD be a very simple setup, directly connected ebgp peers, no multihop, nothing strange. It's not working. On the Cisco side, it shows as an authentication error (at first we weren't doing any, but then turned it on just to see if it made a difference which it did not). But on the Juniper side, the error shows up ONLY in the /var/log/messages file. May 4 00:31:01 Emanon-Edge rpd[2797]: bgp_pp_recv: NOTIFICATION sent to 10.255.255.2+34211 (proto): code 2 (Open Message Error) subcode 5 (authentication failure), Reason: no group for 10.255.255.2+34211 (proto) from AS 7963 found (peer idled), dropping him
This was the same message with or without authentication enabled on the BGP portion. When I do a "monitor interface" to try to watch the traffic, I don't even SEE any outbound bgp traffic. Same thing with traceoptions detail. This "no group" message is quite vexing. Anyone seen anything like this before? I'm hoping it's something simple and driven by lack of sleep, but nothing is leaping at me. TIA, Scott _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp