> -----Original Message----- > From: [EMAIL PROTECTED] [mailto:juniper-nsp- > [EMAIL PROTECTED] On Behalf Of Brendan Mannella > Sent: Tuesday, June 03, 2008 12:52 PM > To: juniper-nsp@puck.nether.net > Subject: [j-nsp] Interface Errors > > > > Hello, i have a M7i with a FE-4FE-TX, and i am seeing collisions on > the interfaces. I am using two ports of the four, and both are > showing the errors. I am also seeing some FIFO errors. Are these > signs of a faulty PIC or should i not be concerned? Thoughts? > > > > Thanks in Advance.
You should ensure that both ends of the link are configured appropriately. Either set them both to 100/full or set them both to autonegotiate. You cannot have one side set to auto and one side set manually, or you will end up with this behavior. Also, previous comments are correct, in that collisions are normal on half-duplex ethernet. _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp