I have a case about that issue (Case #2008-0703-0196 ) and Juniper said that: -round robin load sharing isn't supported for dynamic interfaces; alternate solution can be to use MLPPP for my case MLPPP is not possible because the incumbent who owns LAC does not permit it.
Also for dynamic subscriber interfaces I have another case about dynamic routing protocols which has a similar answer: - OSPF cannot be run on dynamic IP interfaces. (because of KA26012 Juniper removed this feature) I think these two problem is unacceptable and I cannot find any meaningful reason for this kind of lack. On Tue, Aug 26, 2008 at 11:59 AM, Dave Kruger < [EMAIL PROTECTED]> wrote: > Hi All > > Has anyone ever tried to do change the load balancing technique over > l2tp tunnels on an ERX? > > the default is obviously per-flow: > > sh ip interface tun l2tp:139254/1105340/1016347 | i Multipath > Multipath mode = hashed > > It seems enabling per-packet on the physical interface over which the > l2tp tunnel terminates, with the command "ip multipath round-robin" has > no effect: > > sh ip int FastEthernet4/3.302 | i Multipa > Multipath mode = round-robin > > And I see no place to do this under the l2tp destination profile or the > profile it references > > thanks for your time and any feedback > > Regards, > Dave > > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp