Hi there, I have predominantly used cisco and have recently forayed into the land of juniper and have the following question regarding a J2320 with junos 9.
I have a j2320 with a 100meg metro ethernet connected on interface 0 with a /30 link subnet (for example 10.0.0.0./30) this is also the default gateway. Interface 1 is connected to a 10meg metro Ethernet with a /30 link subnet (10.0.1.0/30). What I am looking to do is have everything go across the 100meg link and if that goes down then route through the 10 meg. The only problem is that on interface 0 the link may not show as down as the provider connection is through a switch and the fibre behind that may break. In cisco land I would use object tracking and set up a rule to ping the default gateway on interface 0 and when that became unreachable then it would automagically failover. The juniper kb gives reference to track-ip but it doesn't seem to be avail on j series routers. Any help appreciated. Nick ________________________________ -- This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error please notify the sender. Any offers or quotation of service are subject to formal specification. Errors and omissions excepted. Please note that any views or opinions presented in this email are solely those of the author and do not necessarily represent those of Lumison and nPlusOne. Finally, the recipient should check this email and any attachments for the presence of viruses. Lumison and nPlusOne accept no liability for any damage caused by any virus transmitted by this email. _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp