Hi Tim, You could do load balancing using M7i, but only works on label-1 or label-1+label-2 mpls. So you must get those labels to be different. I have already had this kind of setup in my M10i box with standard CFEB, it should apply the same with M7i.
BR, Benny On Mon, Sep 21, 2009 at 2:40 PM, <tim.h...@bt.com> wrote: > It may depend on the environment you are trying to perform load sharing > in, but we were informed by J-TAC that the M7i CFEB could not perform > MPLS loadsharing across 2 equal cost paths - I'd love to be proved wrong > ;-) An Enhanced CFEB would be required :( > > May be worth checking with J-TAC for your particular case. > > Cheers, > Tim. > > > On Wed, Sep 16, 2009 at 4:47 PM, Shiva Shankar > <shanka...@gmail.com>wrote: > > > >> Hi Gebts Ladies.....A quick question on load balancing on juniper > M7i > >> running Junos 8.4R2..The config I have on the router is: > >> > >> family mpls { label-1; payload { ip; } } > >> > >> The documentation says, for load-balacing (or load sharing per flow), > the > >> above uses label-1 (which is VPN label) and bits of IPv4 addess..My > >> question > >> is, (i) does it includes all the bits in an IPv4 address or just few > bits > >> of IPv4 address? cheers > ******* > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp