>>On the EX-series the ports don't actually show up until you insert an >>optic (this is true for GE and 10GE on all EX's AFAIK). As soon as you >>do insert the SFP, the port will show up, and you'll start graphing it.
OK, now that's confirmed =) However, I can't see the other ports with SNMP without plugging in a SFP. If I try to specify an ifindex (for a port without a SFP) when doing a snmpget I get no answer. I can specify an ifindex with for a port with a SFP just fine. // Olof On Tue, Jun 1, 2010 at 11:57 AM, Richard A Steenbergen <r...@e-gerbil.net> wrote: > On Tue, Jun 01, 2010 at 08:52:53AM +1000, Olof Kasselstrand wrote: >> Hi, >> >> I have a EX4200 24 SFPs switch. When I try show interface terse only >> the port with SFP is shown. If I do a show inter ge-0/0/7 I get device >> not found if there is no SFP plugged in. Is it possible to change >> this? >> >> This is causing me trouble when I want to setup graphs for this >> switch. The interfaces don't show up in SNMP either. It would be nice >> to add all ports and as soon as I start using one port I'll get the >> graphs. > > On the EX-series the ports don't actually show up until you insert an > optic (this is true for GE and 10GE on all EX's AFAIK). As soon as you > do insert the SFP, the port will show up, and you'll start graphing it. > > This is really only a problem if you use some horrible SNMP poller with > static ifindex mappings (like MRTG), in which case the answer should be > to upgrade your SNMP poller as fast as is humanly possible. > > -- > Richard A Steenbergen <r...@e-gerbil.net> http://www.e-gerbil.net/ras > GPG Key ID: 0xF8B12CBC (7535 7F59 8204 ED1F CC1C 53AF 4C41 5ECA F8B1 2CBC) > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp