Hello, Not directly in CLI.
Moreover, It depends of your hash parameters. You have some commands at PFE level to compute the hash key (JSIM commands) Regards David -----Message d'origine----- De : juniper-nsp-boun...@puck.nether.net [mailto:juniper-nsp-boun...@puck.nether.net] De la part de L Kennedy Envoyé : lundi 30 août 2010 13:41 À : juniper-nsp@puck.nether.net Objet : [j-nsp] monitor LACP load-balancing? Hi, Is there any way to monitor the functioning of LACP load-balancing within Junos? I have a LACP group of 8 interfaces and I want to see which particular interface a certain traffic flow is using. On a Cisco 6500 I can run "test etherchannel load-balance..." from the switching module, but I can't find any equivalent juniper command that will allow me to see in detail what the load-balancing algorithm is doing. This is on an EX4200 running 10.0 btw. thanks, Liam. _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp ********************************* This message and any attachments (the "message") are confidential and intended solely for the addressees. Any unauthorised use or dissemination is prohibited. Messages are susceptible to alteration. France Telecom Group shall not be liable for the message if altered, changed or falsified. If you are not the intended addressee of this message, please cancel it immediately and inform the sender. ******************************** _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp