Hi, I am testing the RE based flow export from my Juniper M7i running 9.2R2.15 , for some reason my flow analyzer wrapped up all the flows in instance 0 interface for all the flows exported, at the same time all the export from all the Cisco is working and showing up perfectly.
Upon investigating the sflow packets through wireshark, it is found that all the captured sflow frames from M7i has Input interface and Output interface information id is "0" thus Interface ID is not exported. Is this the know issue or are there any configuration miss? any workaround or fix? ### Wireshark output: > pdu 1/29 SrcAddr: 202.xx.xx.xx (202.xx.xx.xx) DstAddr: 195.xx.xx.xx (195.xx.xx.xx) NextHop: 125.xx.xx.xx (125.xx.xx.xx) InputInt: 0 <---------- here... OutputInt: 0 <---------- here... Packets: 1 Octets: 48 > [Duration:0.000000000 seconds] SrcPort: 48129 DstPort: 28158 padding TCP Flags: 0x00 Protocol: 17 IP Tos: 0x00 #### interfaces { ge-1/3/0 { unit 0 { family inet { filter { input all; output all; } address 202.xx.xx.xx/26; address 202.xx.xx.xx/27; } } } } firewall { filter all { term all { then { sample; accept; } } } } forwarding-options { sampling { input { family inet { rate 100; } } output { cflowd 202.xxx.xxx.xxx{ port 2055; version 5; } flow-inactive-timeout 15; flow-active-timeout 60; } } } ### Chassis M7i Midplane REV 05 M7i Midplane Power Supply 0 Rev 05 AC Power Supply Routing Engine REV 01 RE-850 CFEB REV 08 Internet Processor II FPC 0 E-FPC PIC 0 REV 09 1x G/E, 1000 BASE-SX FPC 1 E-FPC PIC 2 BUILTIN 1x Tunnel PIC 3 REV 08 1x G/E, 1000 BASE Xcvr 0 SFP-SX Fan Tray Rear Fan Tray ### -- Regards Samit _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp