On 11/3/2011 2:28 PM, Jack Bates wrote:
On 11/3/2011 1:45 PM, Terry Jones wrote:
Simple enough using a vlan-ccc. The problem is that I have to setup the
vlan-ccc over a GRE tunnel. Now the question I have is how to make it
layer
2 to the GE interface? Since I can using a vlan-ccc, vlan-ccc and family
inet cannot be configured on the same vlan-id, so I cannot terminate the
GREs on the same endpoints (GE) that I need to configure the vlan-ccc.
I would think the GRE is between loopbacks on each router, and then
l2circuit over tldp over rsvp (or perhaps just ldp) over GRE?
Are you saying that you need a layer 2 crossconnect and layer 3 services
on the same vlan?
Or perhaps something similar to this (someone did it on an EX
unsupported, so I suspect it should work fine on nicer stuff).
http://forums.juniper.net/t5/Ethernet-Switching/MPLS-over-GRE-EX4200/td-p/109086
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
