Hi, After I decoded the packet capture as cflow only, i m seeing that output (no template found). Its there under Data section of Cisco NetFlow/IPFIX.
On Sat, Mar 24, 2012 at 2:14 PM, Tima Maryin <timamar...@mail.ru> wrote: > Hi, > > Try Analyze -> Decode as then cflow > > > > On 23.03.2012 22:25, Arun Kumar wrote: > >> Hi NSP, >> >> I configured IPFIX in juniper MX running 11.2 R3. I run wireshark in flow >> collector where i m getting flows from the juniper router but all data are >> showing "no template found"? What is the problem in this? I had a problem >> on the same router where i was told to move to another PIC/port. I ve done >> the same but now getting this error? What could be the cause of this? Is >> the router not supporting the flow or not sending the flow in proper >> format? >> >> thanks in advance >> Arun >> > > ______________________________**_________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/**mailman/listinfo/juniper-nsp<https://puck.nether.net/mailman/listinfo/juniper-nsp> > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp