Hi Huan, This is not currently possible on a Junos OS router. You must assign the address or at least the prefix portion of the address and then use EUI-64 to auto-generate the interface ID portion, which is based on the interface's hardware address. Hope this helps.
Jared ________________________________ From: Huan Pham <drie.huanp...@gmail.com> To: juniper-nsp@puck.nether.net Sent: Wednesday, January 16, 2013 3:32 AM Subject: [j-nsp] Cannot auto-configure the router interface IPv6 address? Hi list, Could someone please confirm if we can or can not configure the router interface to get an IPv6 address automatically. I read more than one place that says this is not possible, but I could not find an official link from Juniper website to confirm it. It is disappointing, if this is the case. Regards, Huan On Mon, Jan 14, 2013 at 11:00 PM, Huan Pham <drie.huanp...@gmail.com> wrote: > Hi all, > > I would like to do a simple test to make sure that SLAAC configuration on > R1 is working as expected. However, I do not want to use a real PC > connected to it to test, but I want to use another router (R2) as client. > Could you please let me know if it is possible, and how it is done in > Junos. Thanks. > > Below is what I try to achieve if it is done in Cisco world. > > R2(config-if)#interface gig/0 > R2(config-if)#ipv6 address autoconfig > R2(config-if)# > > Thanks in advance. > > Cheers, > > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp