Just a note - I know that on some Cisco phones using EX2200-12C switches we needed to use crossover cables to connect the phones.
That was in the release notes for the switches - at the time we were running 11.4R5.5 -----Original Message----- From: Patrick Okui [mailto:po...@psg.com] Sent: Tuesday, February 04, 2014 5:04 AM To: Robert Hass Cc: juniper-nsp@puck.nether.net Subject: Re: [j-nsp] PoE for older Cisco IP Phones Hi Robert, On 4-Feb-2014 01:41:35 (+0300), Robert Hass wrote: > Patrick, > I just connected 7912 and 7940 to EX4200. Works without issues. Tested > few images. Got signal that EX3200 also do the job. But what about > EX3300 and EX2200 (I don't have any of them for testing) I stand corrected. I didn't think it would work from past experience. In my case the POE switch I was testing (non Juniper) was a Type B (only). In addition to the document Skeeve posted, I found an explanation of how cisco POE works and how you could make it work with switches like the one I tested. <http://www.voip-info.org/wiki/view/Cisco+POE> -- patrick _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp