On 6/19/15 07:00, Adam Vitkovsky wrote: > Hi Folks, > > Is there a way to make the "set class-of-service schedulers Class_1 > transmit-rate percent 20" > to actually use "class-of-service interfaces ge-1/3/0 unit 0 shaping-rate 4m" > when allocating BW for the class please? > > Thank you very much > > adam
A percentage based transmit rate on a scheduler when applied via map to a logical unit with a shaping rate should be the set percentage of the shaping rate, not the native interface rate. (in this case, transmit rate would be 800,000bps) I am assuming (based on the configuration example) that you are in per-unit mode with a per unit capable platform/linecard even though the example is unit 0. It should work the same with port mode only platforms, but the shaper would be on the port, not the port/unit -- ------------------------------------------------------------------------ Christopher E. Brown <chris.br...@acsalaska.net> desk (907) 550-8393 cell (907) 632-8492 IP Engineer - ACS ------------------------------------------------------------------------ _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp