Hi,
I was playing around with a 10G test set and sending 68 byte packets at
layer3 to a 10G port on a DPCE-R-4XGE-XFP and I'm seeing receive FIFO
errors incrementing and packet loss above about 7.1gb. The docs says if
that counter is ever non-zero it could be a bad PIC but I've tried two
different cards, SCBs, XFPs, etc. and it's the same result This is on
an MX240 13.3R7.4 with SCB-MX960-S.
It performs at full 10G with imix traffic and anything above about 88
byte packets so this would probably never be seen in the real world but
I was curious if anyone had seen this and/or if there are any knobs that
can tune it?
Thanks,
Kevin
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
