But for MX240, MX480 and MX960 you will need to combine SCB, MPC and MIC to test the chassis ...
There is a lot of combinations and possibilities ... SCBE, SCBE2, MPC1, MPC2, MPC3, MPC4, MPC5, NG-MPC-2 and NG-MPC-3. A lot of MIC types ... gig, 10gig, 40gig and 100gig ... Are you going to test performance Gbps and PPS ? Using TCP and UDP ? Mixed mode and 64 bytes ? Att, Giuliano Giuliano Cardozo Medalha Systems Engineer +55 (17) 3011-3811 +55 (17) 98112-5394 JUNIPER J-PARTNER ELITE giuli...@wztech.com.br http://www.wztech.com.br/ WZTECH is registered trademark of WZTECH NETWORKS. Copyright © 2015 WZTECH NETWORKS. All Rights Reserved. IMPORTANTE: As informações deste e-mail e o conteúdo dos eventuais documentos anexos são confidenciais e para conhecimento exclusivo do destinatário. Se o leitor desta mensagem não for o seu destinatário, fica desde já notificado de que não poderá divulgar, distribuir ou, sob qualquer forma, dar conhecimento a terceiros das informações e do conteúdo dos documentos anexos. Neste caso, favor comunicar imediatamente o remetente, respondendo este e-mail ou telefonando ao mesmo, e em seguida apague-o. CONFIDENTIALITY NOTICE: The information transmitted in this email message and any attachments are solely for the intended recipient and may contain confidential or privileged information. If you are not the intended recipient, any review, transmission, dissemination or other use of this information is prohibited. If you have received this communication in error, please notify the sender immediately and delete the material from any computer, including any copies. On Sun, Feb 7, 2016 at 9:11 PM, Shanawaz <shana...@gmail.com> wrote: > Hi Tomasz, > > We are looking to run the test on a few different MX platforms (5, 80, 240, > 480, 960) > > > > On Thu, Feb 4, 2016 at 6:43 PM, Tomasz Mikołajek <tmikola...@gmail.com> > wrote: > > > Hi. > > You can configure rfc 2544 test. What Juniper device you have? > > > > > > W dniu czwartek, 4 lutego 2016 Shanawaz <shana...@gmail.com> napisał(a): > > > >> Hey Folks, > >> > >> Are there any tools similar to iperf (or ttcp on cisco) that we can run > >> between 2 Juniper routers (from the CLI or the shell) to test throughput > >> between the 2 devices? > >> > >> We are suspecting a hard rate-limit placed in an upstream ISP segment > >> between the 2 devices. It would be nice just to test between the routers > >> at > >> both ends of the ISP segment rather than using machines that are a few > >> more > >> subnets away. > >> > >> Thanks, > >> Shan > >> _______________________________________________ > >> juniper-nsp mailing list juniper-nsp@puck.nether.net > >> https://puck.nether.net/mailman/listinfo/juniper-nsp > >> > > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp