[Kaboodle-devel] GUI modifications

[mailbox]

Hello Scott, I have fixed the bugs that you had mentioned below and also added the “Disconnect” button in Network Property Page of VPN partner. I am  not yet done with caching the view of My PC’s LAN. I will update the code for that as soon as I finish that. I have sent you the mail regarding the code update for 2nd GUI point (making a group private...). Did you get chance to test that code? Please let me know the results, whenever you will do it. I have my e-mail ID [EMAIL PROTECTED] for official correspondence. Can you please add this address to the kaboodle-developers list, so that I can get all further e-mails on this address? Thanks and Regards, Minal >----- Original Message ----- >From: "Scott C. Best" <[EMAIL PROTECTED]> >To: "mailbox" <[EMAIL PROTECTED]> >Cc: <[EMAIL PROTECTED]> >Sent: Tuesday, October 22, 2002 12:06 PM >Subject: Re: VNC code status > > >> VK, Minal: >> >> Hello! The first pass GUI enhancements look good. >> Please change these two things and add the third: >> >> 1. The column of "My Engaged Networks" is too wide. It should only >>    be ~90 pixels. It should read "My Engaged</n>Networks" at the >>    top. >> >> 2. Please allow up-arrow and down-arrow to work in the list of >>    Engaged networks. >> >Do the up-arrow and down-arrow should work similar to how it works for >normal Device Icons? Also do the right hand side Network view for the >selected Network need to be changed according to the arrow movements? > > > > >> 3. If I open the Network Icon for an Engaged Partner, please >>    put a "Disconnect" button there. Right now, it shows the >>    "Master Node" for my network, which isn't very helpful. So, >>    for my LAN, show the "MASter Node" selection. For a remote >>    LAN, a "Disconnect" button. >> >By above point, do you mean that the whole group box "Kaboodle Master Node:" >should be replaced with the "Disconnect" button? > >Clicking the "Disconnect" button will lose the VPN connection with the >corresponding partner. Is it correct? Please let me know if I am going >wrong. > > >> Thanks! >> >> -Scott >> >> >> On Fri, 18 Oct 2002, mailbox wrote: >> >> >        Hello Scott, >> > >> > >> > >> > I had send a mail regarding the final code update of VNC+VPN module few >days before. But I didn't get any reply from you on that. Did you get a >chance to test the final VNC+VPN code? Can you please update me with the >results on your side? >> > >> > >> > >> > Thanks and Regards, >> > >> > Varsha >> >