https://bugs.kde.org/show_bug.cgi?id=397554
Bug ID: 397554
Summary: Digikam crashes while running BatchQueueManager
Product: digikam
Version: 5.6.0
Platform: Mint (Ubuntu based)
OS: Linux
Status: UNCONFIRMED
Severity: normal
Priority: NOR
Component: BatchQueueManager
Assignee: digikam-bugs-n...@kde.org
Reporter: ich.glaub.an.dich+bugs...@gmail.com
Target Milestone: ---
Created attachment 114466
--> https://bugs.kde.org/attachment.cgi?id=114466&action=edit
Screenshot of log.
I previously used Lubuntu (18.04), and just barely switched to Mint 19 Tara
XFCE release.
I've added several photos to the current batch queue manager, added about 7
steps in the workflow, and started running the queue. It will run fine for at
least five minutes, processing several photos successfully. I'll leave my
desk, and come back sometime later to find that Digikam has closed completely,
crashed, with no explanation. This particular problem was not happening in
Lubuntu 18.04 before I switched, but I've repeated it three times in Mint. In
Lubuntu, whenever Digikam would crash, I would get the bug report prompt, but
that isn't happening this time. I will investigate that. However, I did check
the directories where the photos were being stored, and there were several that
were not processed and or cut short of being processed fully.
My technical skill level is slightly above average - I've been using GNU+Linux
for about ten years, but I may need instructions on how to provide any further
relevant information.
I did search my system logs and found the following message.
Thread (pooled)[313]: segfault at 0 ip 00007ff87a4924b0 sp 00007ff761577da0
error 4 in libdigikamcore.so.5.6.0[7ff87a0da000+d18000]
--
You are receiving this mail because:
You are watching all bug changes.
