https://bugs.kde.org/show_bug.cgi?id=438103
--- Comment #4 from so...@jayaweera.com --- Sorry for sending multiple messages, I just found that when I switched my pen API to the Windows 8+ pointer input, the issue changed to be the exact opposite. At the start of the stroke it would be small and then it would go to the regular settings of the brush, and the Tablet tester showed a blue line. When I did varying pressure for the S this time, the P value changed, as well as when I lifted up the stylus a red line appeared, and when I did constant pressure for the l the P stayed at 0.0% and there was no red line. Attached are the screenshots. Thank you for you time! -------- Original Message -------- Subject: RE: [krita] [Bug 438103] Brush shape irregular at start of stroke From: "Sorin Jayaweera" < so...@jayaweera.com[1]> Date: Sun, June 06, 2021 4:28 pm To: " bug-cont...@kde.org[2]" < bug-cont...@kde.org[2]> So the issue is with the very beginning of the stroke, it always starts with a big blob and then changes to follow its regular pressure. Also, I have the tablet tester but I don't see anything that displays pressure sensitivity, just its location in coordinates and some value for B. Also, on my device I do not have a blue line as stated in the Krita help page, so it may be a problem with my computer specifically. The left panel of the tablet tester reads:x=#(from 59 to 64 ) y= #(from 105 to 20) and b=1(never changes even as i vary pressure with my stylus). attached are two screenshots of the Configure Krita page with the Tablet Tester open, although i'm not sure how helpful they will be. For the "S" I had varied pressure, starting strong then growing weak at the tip, and for the "l" I had constant pressure. side note: thanks for responding so quickly to my bug report, and also sorry if I do anything incorrectly when describing the issue, this is my first report. -------- Original Message -------- Subject: [krita] [Bug 438103] Brush shape irregular at start of stroke From: "Ahab Greybeard" < bugzilla_nore...@kde.org[3]> Date: Sun, June 06, 2021 1:20 pm To: so...@jayaweera.com[1] https://bugs.kde.org/show_bug.cgi?id=438103 Ahab Greybeard < ahab.greybe...@hotmail.co.uk[4]> changed: What |Removed |Added ---------------------------------------------------------------------------- Status|REPORTED |NEEDSINFO CC| | ahab.greybe...@hotmail.co[5].u | |k Resolution|--- |WAITINGFORINFO --- Comment #1 from Ahab Greybeard < ahab.greybe...@hotmail.co.uk[4]> --- I don't see that happen with version 4.4.3 running on Debian 10 with a Wacom Intuos Draw tablet. A very low pressure start to the stroke gives a very small starting size followed by increasing size with increasing pressure, for brushes with that designed characteristic. Can you use the Table Tester to check the pen pressure values at the start of a stroke when doing a low pressure start? -- You are receiving this mail because: You reported the bug. 1. mailto:so...@jayaweera.com 2. mailto:bug-cont...@kde.org 3. mailto:bugzilla_nore...@kde.org 4. mailto:ahab.greybe...@hotmail.co.uk 5. mailto:ahab.greybe...@hotmail.co -- You are receiving this mail because: You are watching all bug changes.