Yes. You can do it just like this in the subnet section (this is for DHCPv6
but i imagine v4 is similar):
"subnet6": [
{
"valid-lifetime": 600,
"preferred-lifetime": 540,
"subnet": "2001:0:2f50:f8::/64",
"pools": [
{
"pool":
"2001:0:2f50:f8::1-2001:0:2f50:f8:ffff:ffff:ffff:fffe"
}
],
I think you can also place the timers inside the pools section if I'm not
mistaken...
----- Original Message -----
> From: "Jeronimo" <[email protected]>
> To: "kea-users" <[email protected]>
> Sent: Friday, August 27, 2021 11:32:31 AM
> Subject: [Kea-users] Pool valid-lifetimer
> Hi,
> Is there a way to configure a specific "valid-lifetimer" value for a pool
> inside
> a subnet?
> Regards,
> Jeronimo
> _______________________________________________
> ISC funds the development of this software with paid support subscriptions.
> Contact us at https://www.isc.org/contact/ for more information.
> To unsubscribe visit https://lists.isc.org/mailman/listinfo/kea-users.
> Kea-users mailing list
> [email protected]
> https://lists.isc.org/mailman/listinfo/kea-users
_______________________________________________
ISC funds the development of this software with paid support subscriptions.
Contact us at https://www.isc.org/contact/ for more information.
To unsubscribe visit https://lists.isc.org/mailman/listinfo/kea-users.
Kea-users mailing list
[email protected]
https://lists.isc.org/mailman/listinfo/kea-users
