** Changed in: linux-raspi2 (Ubuntu Focal)
Status: New => Fix Committed
--
You received this bug notification because you are a member of Kernel
Packages, which is subscribed to linux-raspi2 in Ubuntu.
https://bugs.launchpad.net/bugs/1869180
Title:
focal/linux-raspi2: Upstream raspberrypi patchset 2020-03-27
Status in linux-raspi2 package in Ubuntu:
Fix Committed
Status in linux-raspi2 source package in Focal:
Fix Committed
Bug description:
Upstream raspberrypi patchset 2020-03-27
Ported from the following raspberrypi branch:
rpi-5.4.y
from https://github.com/raspberrypi/linux.git
drm/modes: parse_cmdline: Explicitly memset the passed in drm_cmdline_mode
struct
drm/modes: parse_cmdline: Remove some unnecessary code (v2)
drm/modes: parse_cmdline: Add support for specifying panel_orientation (v2)
drm/modes: parse_cmdline: Allow specifying stand-alone options
drm/modes: parse_cmdline: Set bpp/refresh_specified after successful parsing
drm/modes: parse_cmdline: Add freestanding argument to
drm_mode_parse_cmdline_options()
drm/modes: parse_cmdline: Rework drm_mode_parse_cmdline_options()
drm/modes: parse_cmdline: Accept extras directly after mode combined with
options
drm/modes: parse_cmdline: Stop parsing extras after bpp / refresh at ', '
drm/modes: parse_cmdline: Make various char pointers const
drm/modes: parse_cmdline: Fix possible reference past end of string
net: bcmgenet: Clear ID_MODE_DIS in EXT_RGMII_OOB_CTRL when not needed
ARM: dts: bcm271x: Use a53 pmu, drop RPI364
ARM: dts: bcm2711: Add 32-bit PMU compatibility
Add support for merus-amp soundcard and ma120x0p codec
gpio-ir-overlay: add parameter to configure signal polarity (#3490)
drm/vc4: Add DRM_FORMAT_P030 support to firmware-kms
drm/fourcc: Add packed 10bit YUV 4:2:0 format
drm/vc4: fkms: Change crtc_state structure name to avoid conflict
media: ov5647: change defaults to better match raw camera applications.
media: ov5647: Add extra 10-bit sensor modes.
media: ov5647: Add V4L2 controls for analogue gain, exposure and AWB
media: ov5647: Add basic support for multiple sensor modes.
media: ov5647: Fix return codes from ov5647_write/ov5647_read functions.
Kbuild: Allow .dtbo overlays to be built, adjust.
overlays: imx219: Correct link frequency to match the upstream driver
media: i2c: Add driver for Sony IMX219 sensor
media: dt-bindings: media: i2c: Add IMX219 CMOS sensor binding
Revert "media: dt-bindings: Add binding for the Sony IMX219 sensor"
Revert "media: i2c: Add driver for Sony IMX219 sensor"
bcm2711-rpi.dtsi: Use upstream pcie node
PCI: brcmstb: Fix build on 32bit ARM platforms with older compilers
PCI: brcmstb: Add MSI support
PCI: brcmstb: Add Broadcom STB PCIe host controller driver
ARM: dts: bcm2711: Enable PCIe controller
dma-mapping: treat dev->bus_dma_mask as a DMA limit
dma-direct: exclude dma_direct_map_resource from the min_low_pfn check
dma-direct: avoid a forward declaration for phys_to_dma
dma-direct: unify the dma_capable definitions
PCI: of: Add inbound resource parsing to helpers
x86/PCI: sta2x11: use default DMA address translation
dma-direct: check for overflows on 32 bit DMA addresses
dma/direct: turn ARCH_ZONE_DMA_BITS into a variable
resource: Add a resource_list_first_type helper
mm: refresh ZONE_DMA and ZONE_DMA32 comments in 'enum zone_type'
arm64: use both ZONE_DMA and ZONE_DMA32
arm64: rename variables used to calculate ZONE_DMA32's size
arm64: mm: use arm64_dma_phys_limit instead of calling max_zone_dma_phys()
of: Make of_dma_get_range() work on bus nodes
of/address: Translate 'dma-ranges' for parent nodes missing 'dma-ranges'
of: Factor out #{addr,size}-cells parsing
of: address: Follow DMA parent for "dma-coherent"
of/address: Introduce of_get_next_dma_parent() helper
Revert "dma-direct: check for overflows on 32 bit DMA addresses"
Revert "arm64/mm: Limit the DMA zone for arm64"
Revert "PCI: brcmstb: Add Broadcom STB PCIe host controller driver"
Revert "PCI: brcmstb: Add dma-range mapping for inbound traffic"
Revert "PCI: brcmstb: Add MSI capability"
Revert "pcie-brcmstb: Changes for BCM2711"
Revert "bcm2835-dma: Add proper 40-bit DMA support"
Revert "bcm2835-dma: Correct SoC name"
Revert "pcie-brcmstb: Don't set DMA ops for root complex"
Revert "Ported pcie-brcmstb bounce buffer implementation to ARM64. (#3144)"
Revert "pcie-brcmstb-bounce64.c: dev_err() -> dev_info() for info messages"
Revert "pcie-brcmstb: Eliminate arch_dma_ops error message"
Revert "pcie-brcmstb: Bounce buffer support is for BCM2711B0"
Revert "pcie-brcmstb: Correct SoC name"
Revert "ARM: dts: bcm283x: Restore simple-bus to /clocks"
ARM: dts: bcm283x: Restore simple-bus to /clocks
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/linux-raspi2/+bug/1869180/+subscriptions
--
Mailing list: https://launchpad.net/~kernel-packages
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kernel-packages
More help : https://help.launchpad.net/ListHelp
