I think /etc/modules.conf is what you are looking for. Use it to add your modules configuration.
Regards, Prateek On Mon, Sep 9, 2013 at 8:09 PM, Tushar Dave <tush...@gmail.com> wrote: > Hi Prateek, > I want to know if there is a config file which has > entries for the modules that the kernel loads at runtime .How does the > kernel know which device has been connected and which kernel module to > load.There has to be some kind of mapping between them. > > Thanks for the prompt reply, > Tushar Dave > > > On Sat, Sep 7, 2013 at 3:11 AM, Prateek Saxena < > thisisprateeksax...@gmail.com> wrote: > >> If you are just trying to get the phone work I suggest that you recompile >> the untainted kernel and check if it loads. Also, trying to figure out why >> it wont connect without a list of changes is difficult. >> >> >> Regards, >> Prateek >> >> >> On Sat, Sep 7, 2013 at 12:45 AM, Tushar Dave <tush...@gmail.com> wrote: >> >>> Hi, >>> I am facing an unusual problem.I have a ubuntu PC with 11.10 >>> installed on it and it has a driver called cdc_ether.ko.Now when I connect >>> a mobile phone to the PC the driver does not get loaded automatically.I had >>> made a lot of changes in the udev rules earlier and then replaced it with >>> the default one ( I had kept it as a backup).Earlier the phone used to >>> connect properly and the driver got loaded automatically and I also used to >>> see a new interface on doing an ifconfig but now that is not the case.I >>> think I have changed some settings in my Ubuntu PC which has lead to this. >>> >>> Any suggestions >>> >>> Thanks >>> Dave >>> >>> _______________________________________________ >>> Kernelnewbies mailing list >>> Kernelnewbies@kernelnewbies.org >>> http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies >>> >>> >> >
_______________________________________________ Kernelnewbies mailing list Kernelnewbies@kernelnewbies.org http://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies