On 7/6/22 10:58, A mp wrote:
I believe I tried that, I seen a similar solution on stack overflow, something
about changing the log level?
That should work since pr_info is just a macro:
/**
* pr_info - Print an info-level message
* @fmt: format string
* @...: arguments for the format string
*
* This macro expands to a printk with KERN_INFO loglevel. It uses
pr_fmt() to
* generate the format string.
*/
#define pr_info(fmt, ...) \
printk(KERN_INFO pr_fmt(fmt), ##__VA_ARGS__)
and you're setting the log level even higher to DEBUG.
cat /proc/sys/kernel/printk shows you the current log level
Any other suggestions perhaps?
Thanks,
Andrew.
On Wed, Jul 06, 2022 at 10:53:12AM +0300, Denis Kirjanov wrote:
On 7/6/22 09:47, A mp wrote:
Hi everyone,
My name is Andrew.
Recently, I went through the Linux Foundations intro to kernel development
course. As part of the course, it gets us to put a print statement inside of
the uvcvideo driver, recompile the kernel and then load the module and check
dmesg for the print statement.
After several attempts, I was unable to find this print statement inside of
dmesg. I know that the modified drier was compiling successfully and my custom
kernel was indeed installed but no idea about this pr_info statement.
I tried this in Ubuntu and Fedora inside of virtualbox. Not sure if that would
make any difference.
echo "7" > /proc/sys/kernel/printk
and make sure that you have your module listed in lsmod
Thanks,
Andrew.
_______________________________________________
Kernelnewbies mailing list
[email protected]
https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
_______________________________________________
Kernelnewbies mailing list
[email protected]
https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies
