On 5/12/23 07:26, Matthew Garrett wrote:
On Thu, May 04, 2023 at 02:50:16PM +0000, Ross Philipson wrote:
+static void sl_find_event_log(struct slr_table *slrt)
If this is called after the EFI stub then we're presumably
post-ExitBootServices and we're copied the TPM event log into a
configuration table so it's available to the runtime kernel. That also
means that we should be adding all further measurements to the Final
Events Table rather than the initial event log. How's that handled here,
both in terms of ensuring further events (generated by firmware or by
us) get added to the right place, and in terms of ensuring the event
logs the kernel has later on were covered appropriately? Or is the SL
event log an entirely different thing that can be merged in later
because it only covers the DRTM PCRs?
This is a good point. At this point it is really something we
overlooked. We will have to revisit this and figure out the best way to
find the final event log depending on how things booted.
+static void sl_extend_setup_data(struct slr_policy_entry *entry)
+{
+ struct setup_data *data;
+
+ /*
+ * Measuring the boot params measured the fixed e820 memory map.
+ * Measure any setup_data entries including e820 extended entries.
+ */
+ data = (struct setup_data *)(unsigned long)entry->entity;
+ while (data)
+ data = sl_handle_setup_data(data, entry);
+}
Is e820 sufficient here? There are cases where we use the EFI memory map
directly (sorry), but I don't know if any of them are relevant to DRTM
outcomes.
I am not 100% sure what you are asking but we also measure the EFI
memory map. This comment is just to note that if the e820 exceeded the
space in the fixed map in boot parameters, we would pick up any extra
entries when measuring the setup_data list.
Thanks
Ross
_______________________________________________
kexec mailing list
kexec@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/kexec
