GND was connected to OpenEm pin of a transistor, when I tried to connect PWR_FLAG, ERC detected a input power in the OpenEm of the transistor. I've just put a 0 Ohms resistor between transistor pin and GND.
--- In [email protected], Botjan Jerko <[EMAIL PROTECTED]> wrote: > > Did you also connect GND of the component (with pin 1 as power_in) > to a power component GND? > > Botjan > > On 2007.2.9, at 15:46, arnaud.lemeur wrote: > > > Hi, > > > > When I connect GND to PWR_FLAG, ERC returns an error ("Pin power_out > > connected to a Pin openEm"). But GND pin 1 is power_in when I verify > > by editing component. > > > > What can I do to solve this problem ? > > > > Thanks, > > > > > > > > --- > mag./M.Sc. Botjan Jerko > Botjan Jerko-Japina s.p., Raziskovanje in razvoj novih tehnologij > Botjan Jerko-Japina s.p., Research and development of new technologies > > ******************* > Elektronika/Electronics, > Software/Programi: http://www.japina.eu > slo. blog: http://www.japina.eu/blog-slo > Eng. blog: http://www.japina.eu/blog-eng > trgovina/store: http://www.japina.eu/store >
