Good day
I have a partially completed KR2 (original design) which i bought some
time ago. I need to complete the landing gear (removed the original
retracted type & replace with fixed), engine and instrument panel &
electrics. While hangered the elevator was basically destroyed when
someone drove into it.
I now need to rebuild the elevator completely. My problem is this one is
balanced so there is a counterweight attached to the spar inside body. I
need to remove it but will need to cut into some areas to access it.
What would be the best option? Cut into the side of the body? I think
this is structurally not good. Else remove the tail fin? Would not like
to cut the wooden spars at all! So will need to carefully need to cut
out skin/foam and not damage spars?
I was thinking that in the process I should reduce pitch sensitivity by
enlarging the tail area as well. So removing the aft spar of the
horizontal stabilizer and install a longer one.
Suggestions?
Regards
Deon
_______________________________________________
Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search.
Please see LIST RULES and KRnet info at http://www.krnet.org/info.html.
see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change
options
To UNsubscribe from KRnet, send a message to [email protected]
