Can someone direct me to a thread about using the Ray Allen trim systems on a kr2. I am new to figuring out this whole krnet thing.
Sent from my T-Mobile 4G LTE Device -------- Original message --------From: John Martindale via KRnet <krnet at list.krnet.org> Date: 5/11/16 5:01 PM (GMT-05:00) To: 'KRnet' <krnet at list.krnet.org> Cc: John Martindale <john_martindale at bigpond.com> Subject: Re: KR> Firewall Edge Finish Hi Sid I just ran a bead of silastic around the top and sides before clamping the steel and frax to the wall. I left the bottom open just in case something needed to drain out. All good so far. How close are you to flight again? John John Martindale 29 Jane Circuit Toormina NSW 2452 Australia ph:61 2 6658 4767 m:0403 432179 email:john_martindale at bigpond.com web site: -----Original Message----- From: KRnet [mailto:krnet-bounces at list.krnet.org] On Behalf Of Sid Wood via KRnet Sent: Thursday, 12 May 2016 1:10 AM To: krnet at list.krnet.org Cc: Sid Wood Subject: KR> Firewall Edge Finish What method would be used to finish the firewall edge of a stainless steel sheet to keep out water, oil, etc. from getting between the plywood and steel sheet, make a neat interface for the cowl and not add excessive weight? Sid Wood Tri-gear KR-2 N6242 Mechanicsville, MD, USA _______________________________________________ Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. To UNsubscribe from KRnet, send a message to KRnet-leave at list.krnet.org please see other KRnet info at http://www.krnet.org/info.html see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options _______________________________________________ Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. To UNsubscribe from KRnet, send a message to KRnet-leave at list.krnet.org please see other KRnet info at http://www.krnet.org/info.html see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options
