The removable turtle deck that Neil Bingham built had some small alumn. angle bonded or screwed or both to the longeron. The angle was inset just enough for the turtle deck to fit against it and be flush with the fuse. There were nut plates riveted to the inside of the angle every 3or4 inches and the screws he used were counter sunk into the fiberglass. Neil said it took 20 minutes or so to remove it but he said it was worth it the fist time he dropped a tool that would have been almost impossible to get to without the removable deck. ----- Original Message ----- From: larry severson <lar...@socal.rr.com> To: <kr...@mylist.net> Sent: Tuesday, August 12, 2003 3:12 PM Subject: KR>removable turtle deck
> Has anyone looked at an actual removable turtle deck? I would like to have > one. In the absence of other information, I assume that it is achieved with > 3 one ft. hinge sections on each side using removable pins. > > Larry Severson > Fountain Valley, CA 92708 > (714) 968-9852 > lar...@socal.rr.com > > > _______________________________________________ > see KRnet list details at http://www.krnet.org/instructions.html >
