Thanks Ralph, I didn't hear from anybody but you , so to keep this project moving I ordered the bolt from Revmaster for $22.00 (30 min ago before I saw your response), along with my gaskets and seals. --------------------Getting ready the summer of 2004.
On Tue, 20 Jan 2004 16:52:55 -0500 Ralph H Snyder <ralphnd...@juno.com> writes: > The bolt size is 1 1/8 x 5" NC. Drill and tap the threaded end of > the > bolt for 1/2" NC and install a bolt in it. Cut the 1/2" bolt off 2 > 1/4" > long and taper the end the same angle as a drill bit. This will pop > it > off with no problem. > Ralph Snyder > Burbank, CA > > On Sun, 18 Jan 2004 13:30:20 -0500 Kenneth L Wiltrout > <klw1...@juno.com> > writes: > > > > I'm pulling down the 2100 Revmaster to reseal it. Any body know > the > > bolt > > size that acts as the prop hub puller. > > Thanks Guys. > > > > Looking forward to Sun'n Fun 2004!!!!!!!!! > > > > ________________________________________________________________ > > The best thing to hit the internet in years - Juno SpeedBand! > > Surf the web up to FIVE TIMES FASTER! > > Only $14.95/ month - visit www.juno.com to sign up today! > > > > _______________________________________ > > to UNSUBSCRIBE from KRnet, send a message to > krnet-le...@mylist.net > > please see other KRnet info at > > http://www.krnet.org/instructions.html > > > > > > _______________________________________ > to UNSUBSCRIBE from KRnet, send a message to krnet-le...@mylist.net > please see other KRnet info at > http://www.krnet.org/instructions.html > > ________________________________________________________________ The best thing to hit the internet in years - Juno SpeedBand! Surf the web up to FIVE TIMES FASTER! Only $14.95/ month - visit www.juno.com to sign up today!
