I used 8ea. AN385 taper pins for my wing attach fittings. On the large end I
turned it down and cut some 5/8" threads and drilled it for a cotter pin.
When installed there are two spacers that set the taper pin into position
and are clamped in place by the two nuts. This acts like two short bolts.
Lots of work setting it all up but I can pre load the taper using washers to
take up any slop. I had access to a tapered reamer at the time. The easiest
way is to use one bolt with a spacer, with the WAF's reamed to size. This
step done first then position onto the spars and drill the 3/16th holes.

Joe
Scappoose, Ore. 

Message: 6
List-Post: [email protected]
Date: Sun, 3 Oct 2010 20:00:28 +0200
From: "Eric Evezard" <[email protected]>
Subject: KR> WAF 
To: "KRnet" <[email protected]>
Message-ID: <[email protected]>
Content-Type: text/plain;       charset="iso-8859-1"

Hi Netters,
Has anyone used wing pins to attach the wings ?My sailplane has wing pins
with small handles and thumb push buttons one end with ball bearings at the
other.One simply presses the thumb button,the ball bearings retract,and the
pin slides through the WAFs,Let go and it is locked.It takes no time at
all.Most netters will know all about these pins.I am using the plans bolts
and nuts system on my KR 2s,as I do not intend rigging and de rigging my KR
as I would my glider.(outlandings and retrieval etc )However should the
necessity ever arise (hangarage etc) I would consider wing pins.
Best Regards,
Eric,
South Africa.



Reply via email to