Message: 6
You might try setting the aircraft to the highest angle of attack expected
in flight by placing something under the nose wheel with minimum fuel in the
tank. Then disconnect the fuel output from the gasculator and point it
toward a measuring cup. With a stop watch time the amount of fuel it takes
to fill a specific amount in the cup. Then calculate the gph. 

Joe
Scappoose ore.

List-Post: [email protected]
Date: Thu, 30 Dec 2010 19:43:59 -0500
From: "smwood" <[email protected]>
Subject: KR> Fuel Flow Test
To: <[email protected]>
Message-ID: <F4120461E8C448BAB50E9674CE0A135C@Corp500>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
        reply-type=original

I need to verify the fuel flow rate on my KR-2.  The VW 2180 would burn 
about 6 gallons per hour full throttle 3600 RPM, full rich, max climb rate 
at 14 degrees AOA.  FAA says there must be a 50 percent safety factor.  So, 
need to verify 9 gallon per hour fuel flow.  I cannot just fly to see if the

aircraft will not run out of fuel under these conditions because that would 
not demonstrate the safety factor and a couple of other things.  Other 
considerations:  All fuel is in the wings; have an engine driven mechanical 
fuel pump.  Just windmilling with the starter won't get but a few hundred 
RPM.  I can block up the aircraft on the ground for the 14-degree AOA.  Yes,

I know about the 2-minute max throttle de-rating.
There are lots of references in the archives on flow testing and Facet 
pumps.  I find nothing for on testing engine-driven fuel pumps or how the 
flow was actually measured.
Any suggestions on how I can demonstrate a 9 gallon per hour fuel flow rate?

(which, of course, the 2180 will never need)

Sid Wood
Tri-gear KR-2 N6242
Mechanicsville, MD, USA 






Reply via email to