https://bugzilla.kernel.org/show_bug.cgi?id=23992
--- Comment #4 from Samuel Thibault <samuel.thiba...@ens-lyon.org> 2011-08-15 18:31:28 --- No, it is not a known issue. Which task(s) did you install? Note that you do not need to install GNU/Hurd to build GNU Mach, just git clone git.savannah.gnu.org:/srv/git/hurd/gnumach.git and autoreconf -i && ./configure && make. If you have a 64bit box, you need to cross-compile: CPP='gcc -m32 -E -x c -undef -ansi' CC='gcc -m32' LD='ld -melf_i386' ./configure --host=i686-unknown-linux-gnu Thinking again about, IIRC the kernel will just boot fine, it's only in some application use case that the issue shows up. I'll attach a patch which shows the CR0 value before and after Mach changes it. The 0x20 flag currently shows up both before and after. It should only show up after (because Mach sets it). To easily get the boot logs, pass console=com0 as kernel parameter during the multiboot command, that will direct logs to the serial port. -- Configure bugmail: https://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are watching the assignee of the bug. -- To unsubscribe from this list: send the line "unsubscribe kvm" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
