Hello Jean-Philippe, Jean-Philippe Brucker <jean-philippe.bruc...@arm.com> writes: > Makes sense, though I think other virtio devices have been developed a > little more organically: device and driver code got upstreamed first, > and then the specification describing their interface got merged into > the standard. For example I believe that code for crypto, input and GPU > devices were upstreamed long before the specification was merged. Once > an implementation is upstream, the interface is expected to be > backward-compatible (all subsequent changes are introduced using feature > bits). > > So I've been working with this process in mind, also described by Jens > at KVM forum 2017 [3]: > (1) Reserve a device ID, and get that merged into virtio (ID 23 for > virtio-iommu was reserved last year) > (2) Open-source an implementation (this driver and Eric's device) > (3) Formalize and upstream the device specification > > But I get that some overlap between (2) and (3) would have been better. > So far the spec document has been reviewed mainly from the IOMMU point > of view, and might require more changes to be in line with the other > virtio devices -- hopefully just wording changes. I'll kick off step > (3), but I think the virtio folks are a bit busy with finalizing the 1.1 > spec so I expect it to take a while.
I read v0.9 of the spec and have some minor comments, hope this is a good place to send them: 1. In section 2.6.2, one reads If the VIRTIO_IOMMU_F_INPUT_RANGE feature is offered and the range described by fields virt_start and virt_end doesn’t fit in the range described by input_range, the device MAY set status to VIRTIO_- IOMMU_S_RANGE and ignore the request. Shouldn't int say "If the VIRTIO_IOMMU_F_INPUT_RANGE feature is negotiated" instead? 2. There's a typo at the end of section 2.6.5: The VIRTIO_IOMMU_MAP_F_MMIO flag is a memory type rather than a protection lag. s/lag/flag/ 3. In section 3.1.2.1.1, the viommu compatible field says "virtio,mmio". Shouldn't it say "virtio,mmio-iommu" instead, to be consistent with "virtio,pci-iommu"? 4. There's a typo in section 3.3: A host bridge may limit the input address space – transaction accessing some addresses won’t reach the physical IOMMU. s/transaction/transactions/ I also have one last comment which you may freely ignore, considering it's clearly just personal opinion and also considering that the specification is mature at this point: it specifies memory ranges by specifying start and end addresses. My experience has been that this is error prone, leading to confusion and bugs regarding whether the end address is inclusive or exclusive. I tend to prefer expressing memory ranges by specifying a start address and a length, which eliminates ambiguity. -- Thiago Jung Bauermann IBM Linux Technology Center _______________________________________________ kvmarm mailing list kvmarm@lists.cs.columbia.edu https://lists.cs.columbia.edu/mailman/listinfo/kvmarm