Thanks for your help. My customer is replacing their current PRI with a VOIP T1 PRI and I want to install a second PRI card while it is tested and this will help prevent any down time. But I am not sure how to dial out on the second PRI.
Thanks again -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Thursday, June 30, 2011 2:16 PM To: [email protected] Subject: Re: KX-T: TDA200 with a PRI depends on what the carrier is send you 4 or 7 digits. Can go either way. On a Pri you dial out on any of the 23 channels. To show the DID number to the outgoing caller ID, you need to set CLIP for that extension and have the carrier look for CLIP control from the PBX. Carmen A DeFelice Panasonic Business Phone Systems -----Original Message----- From: Joseph Kral <[email protected]> To: [email protected] Sent: Thu, Jun 30, 2011 1:59 pm Subject: KX-T: TDA200 with a PRI When setting up the DID on the TDA200 with a PRI can I only enter the last four digits of the phone number? Also how would I confirm that I can dial out on that number? Thanks _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
