Paolo Sestini ??: > Felix, > thank you for your reply. >> Paolo Sestini ??: >> >>> Hi all, >>> after installing OpenSolaris 2008.11 on my Toshiba M10 and even after >>> an all package update I was never able to connect to my wireless. >>> >>> I then removed the original SUNWiwh package and installed the driver >>> from http://www.opensolaris.org/os/project/sierra/files/SUNWiwh.tar.gz >>> give the fact that less /etc/release shows: >>> >>> OpenSolaris 2008.11 snv_101a_rc1b X86 >>> Copyright 2008 Sun Microsystems, Inc. All Rights Reserved. >>> Use is subject to license terms. >>> Assembled 05 November 2008 >>> >>> >>> but stil with no success. >>> >>> The following is what I always get: >>> >>> psestini at TitanioPCnew:~$ pkginfo -l SUNWiwh >>> PKGINST: SUNWiwh >>> NAME: Intel(R) WiFi Link 5100/5300 driver >>> CATEGORY: system >>> ARCH: i386 >>> VERSION: 11.11,REV=2008.08.28.01.23 >>> BASEDIR: / >>> VENDOR: Sun Microsystems, Inc. >>> DESC: Intel(R) WiFi Link 5100/5300 driver >>> PSTAMP: jetur20080829102929 >>> INSTDATE: Feb 16 2009 19:42 >>> HOTLINE: Please contact your local service provider >>> STATUS: completely installed >>> FILES: 5 installed pathnames >>> 3 directories >>> 2 executables >>> 1639 blocks used (approx) >>> >>> psestini at TitanioPCnew:~$ su - >>> Password: >>> Sun Microsystems Inc. SunOS 5.11 snv_101a November 2008 >>> You have new mail. >>> root at TitanioPCnew:~# dladm show-link >>> LINK CLASS MTU STATE OVER >>> e1000g0 phys 1500 unknown -- >>> iwh0 phys 1500 down -- >>> root at TitanioPCnew:~# dladm scan-wifi >>> LINK ESSID BSSID/IBSSID SEC STRENGTH MODE SPEED >>> iwh0 Alice-93311681 0:1c:a2:d5:cc:90 wpa good g 54Mb >>> iwh0 Alice-24763054 0:1d:6a:ec:34:f6 wpa good g 54Mb >>> iwh0 SUN 0:11:9:e:4f:67 none excellent g 54Mb >>> iwh0 dlink 2:21:91:1a:7f:39 wpa very good g 54Mb >>> iwh0 alice 0:1a:70:96:fb:a0 wpa good g 54Mb >>> root at TitanioPCnew:~# dladm connect-wifi -e SUN >>> dladm: cannot connect: operation timed out >>> root at TitanioPCnew:~# >>> >> Hi Paolo, >> >> You should use command `ifconfig iwh0 plumb` to plumb your wifi >> interface before scan/connect operation. You can have a try. If it still >> has problem, please let me know. Thanks. >> > I reinstalled the original driver and tried again as suggested but the > outcome is the same. > > psestini at TitanioPCnew:~$ pkginfo -l SUNWiwh > PKGINST: SUNWiwh > NAME: Intel(R) WiFi Link 5100/5300 driver > CATEGORY: system > ARCH: i386 > VERSION: 11.11,REV=2008.10.30.20.37 > VENDOR: Sun Microsystems, Inc. > DESC: Intel(R) WiFi Link 5100/5300 driver > HOTLINE: Please contact your local service provider > STATUS: completely installed > > psestini at TitanioPCnew:~$ su - > Password: > Sun Microsystems Inc. SunOS 5.11 snv_101a November 2008 > root at TitanioPCnew:~# ifconfig iwh0 plumb > root at TitanioPCnew:~# ifconfig -a > lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu > 8232 index 1 > inet 127.0.0.1 netmask ff000000 > iwh0: flags=201000802<BROADCAST,MULTICAST,IPv4,CoS> mtu 1500 index 2 > inet 0.0.0.0 netmask 0 > ether 0:21:6b:b6:bd:d4 > lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu > 8252 index 1 > inet6 ::1/128 > root at TitanioPCnew:~# dladm show-link > LINK CLASS MTU STATE OVER > e1000g0 phys 1500 unknown -- > iwh0 phys 1500 down -- > root at TitanioPCnew:~# dladm show-wifi > LINK STATUS ESSID SEC STRENGTH MODE SPEED > iwh0 disconnected -- -- -- -- -- > root at TitanioPCnew:~# dladm scan-wifi > LINK ESSID BSSID/IBSSID SEC STRENGTH MODE SPEED > iwh0 dlink 2:21:91:1a:7f:39 wpa good g 54Mb > iwh0 SUN 0:11:9:e:4f:67 none excellent g 54Mb > iwh0 alice 0:1a:70:96:fb:a0 wpa good g 54Mb > iwh0 Alice-93311681 0:1c:a2:d5:cc:90 wpa good g 54Mb > root at TitanioPCnew:~# dladm connect-wifi -e SUN iwh0 > dladm: cannot connect: operation timed out > root at TitanioPCnew:~# > > The funny thing is that this problem happens only when I try to > connect to my Draytek Vigor 2600. > Yesterday I happened to be at a friend house and was able to connect > with no problems. > > I set up my Draytek to: > 802.11n > 802.11g > 802.11n+g > > with no difference. > > The /var/adm/messages file show no error. Hi Paolo,
So far, iwh driver has not supported 802.11n, so you'd better set your AP to 802.11g or 802.11n+g. If your wifi can connect to your friend's AP, it seems the configuration of your AP has something different. So please check your Draytek, to see if mac filter is used. ------ Thanks, Felix > > Any more suggestion? > > Thanks. > Paolo >> ------ >> Thanks, >> Felix >> >>> Am I doing something wrong? >>> Can anybody help me? >>> >>> Thanks >>> Paolo >>> -- >>> <http://www.sun.com> * Paolo Sestini * >>> Senior Architect >>> *Sun Microsystems Italia S.p.A.* >>> Centro Pier della Francesca, Corso Svizzera, 185 >>> Torino, TO 10149 ITALY >>> Phone x53631/+39-011-750.3231 >>> Mobile +39-335-575.6168 >>> Fax +39-011-750.3237 >>> Email Paolo.Sestini at Sun.COM >>> >>> */Ho imparato... >>> che tutti vogliono vivere in cima alla montagna.... >>> Ma tutta la felicit? e la crescita avvengono mentre la scali./* >>> >>> <http://www.sun.com> >>> >>> ------------------------------------------------------------------------ >>> >>> _______________________________________________ >>> laptop-discuss mailing list >>> laptop-discuss at opensolaris.org >>> >>> >> >> > > -- > <http://www.sun.com> * Paolo Sestini * > Senior Architect > *Sun Microsystems Italia S.p.A.* > Centro Pier della Francesca, Corso Svizzera, 185 > Torino, TO 10149 ITALY > Phone x53631/+39-011-750.3231 > Mobile +39-335-575.6168 > Fax +39-011-750.3237 > Email Paolo.Sestini at Sun.COM > > */Ho imparato... > che tutti vogliono vivere in cima alla montagna.... > Ma tutta la felicit? e la crescita avvengono mentre la scali./* > > <http://www.sun.com> >
