Michael Li wrote:
> Michael Li wrote:
>> Robert ??:
>>
>>> Thanks a lot, Michael. I downloaded ath driver, but my pkgadd could
>>> not go through successfully. Here is the output of
>>> "/usr/X11/bin/scanpci -v".
>>>
>>>
>>> pci bus 0x0003 cardnum 0x03 function 0x00: vendor 0x14e4 device 0x4318
>>> Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN
>>> Controller CardVendor 0x1028 card 0x0005 (Dell, Card unknown)
>>> STATUS 0x0000 COMMAND 0x0106
>>> CLASS 0x02 0x80 0x00 REVISION 0x02
>>> BIST 0x00 HEADER 0x00 LATENCY 0x40 CACHE 0x00
>>> BASE0 0xdfbfe000 addr 0xdfbfe000 MEM
>>> MAX_LAT 0x00 MIN_GNT 0x00 INT_PIN 0x01 INT_LINE 0x0a
>>> BYTE_0 0x01 BYTE_1 0x00 BYTE_2 0xc2 BYTE_3 0x07
>>>
>>>
>>> This message posted from opensolaris.org
>>> _______________________________________________
>>> laptop-discuss mailing list
>>> laptop-discuss at opensolaris.org
>>>
>>>
>> Hi, Robert,
>>
>> Your WLAN module is bcm4318, we have only ndiswrapper to support it
>> on solaris nevada build 54+, (32 bit kernel only). New ndiswrapper
>> will be uploaded to OpenSolaris/ndis page about next week. It bases
>> on GLDv3, need backport for s10 support. Thanks,
>>
>> Michael
>> _______________________________________________
>> laptop-discuss mailing list
>> laptop-discuss at opensolaris.org
> Hi, Robert,
>
> I found below topic, it should be very helpful for bcm4318 + solaris
> 10 users.
> http://www.opensolaris.org/jive/thread.jspa?messageID=58479
>
> Thanks for bung-foo's blog!
>
> Good luck,
>
> Michael
> _______________________________________________
> laptop-discuss mailing list
> laptop-discuss at opensolaris.org
Sorry, this one:
http://www.opensolaris.org/jive/thread.jspa?messageID=48324별
-
Michael
