Hi martin, Lot of linux users are using imq. But i dont have time to use it. But yes You can do one thing.
Your case etho----wan port 202.14.41.1 eth1---- 192.168.1.0/24 eth1:0---192.168.2.0/24 If you this 2 network connected within the same switch or hub then u can use eth1 for both network if u have different switch or hub for this network then y dont u put the cross cable between this two network and connect it and then manage the bandwidth on both network. give 192.168.1.0/24 bw 512 give 192.168.2.0/24 bw 512 and ceil it both to 512 and u know what u want to do ...when this network is not using the bandwidth allow the other network. its easy u dont need to put the eth2 ..remove it...if u use the about example Joel ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Thursday, July 03, 2003 1:56 AM Subject: [LARTC] HTB burstable for 2 interface , how ? Dear folks, Here goes my bandwidth manager: INTERNET | |eth0 202.14.41.1 BW.Manager | | | +----eth1----192.168.1.0/24 | +------eth2----192.168.2.0/24 Total incoming bandwidth to eth0 is 1024kbps should be shared to eth1 and eth2, which mean each get 512Kbps and burstable to 1024Kbps if other host is idle. My question is how do i apply HTB to these situation ? As far as i know eth1 and eth2 should be define as parent and cannot be as children. Regards, Rio Martin. -------------------------------------------------------------------- mail2web - Check your email from the web at http://mail2web.com/ . _______________________________________________ LARTC mailing list / [EMAIL PROTECTED] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/ _______________________________________________ LARTC mailing list / [EMAIL PROTECTED] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
