tc filter add dev eth1 parent 1:0 prio 10 handle 3: protocol ip u32 divisor 256
tc filter add dev eth1 protocol ip parent 1:0 prio 10 u32 ht 800:: match ip src
10.2.0.0/16 hashkey mask 0x0000ff00 at 12 link 3:
So I have something like this. the first command is saying handle 3 does this mean
it is createing a hash table because of an divisor? and the link command on the
second command would only referecne to a HT?
Yes. An you must fill hashes 3:xx with other filters or just flowid.
Something like this:
tc filter add dev eth1 parent 1:0 protocol ip u32 ht 3:04: order 1 \
match ip dst 1.2.3.4/24 flowid 1:4
or
tc filter add dev eth1 parent 1:0 protocol ip u32 ht 3:04: order 1 \
flowid 1:4
Catalin BOIE ([EMAIL PROTECTED]) wrote:
Is there a relation between the hashtable ID /(parent,handle) so that if I used 2:
for a hash table I could or couldn't use 2: for a (parent,handle)ID?
No relation. You can use the same id for both.
I also noticed that you type the hashtables like 2:2: can you have more levels with
this? like 2:2:2:1: ? and I guess the same question with the parent/handles.
No, you cannot do this.
For hashes check my previous mail, for handler: xxxxyyyy, where xxxx is
qdisc id and yyyy is class id.
thanks again.
--
When dealing with a slow pipe, never underestimate the throughput of the postal
system.
_______________________________________________
LARTC mailing list / [EMAIL PROTECTED]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
---
Catalin(ux aka Dino) BOIE
catab at deuroconsult.ro
http://kernel.umbrella.ro/
--
When dealing with a slow pipe, never underestimate the throughput of the postal system.
---
Catalin(ux aka Dino) BOIE
catab at deuroconsult.ro
http://kernel.umbrella.ro/
_______________________________________________
LARTC mailing list / [EMAIL PROTECTED]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
