> via 10.200.0.2 dev neta2
From: [EMAIL PROTECTED] on behalf of comp.techs
Sent: Thu 10/27/2005 10:02 AM
To: Edmundo Carmona; lartc@mailman.ds9a.nl
Subject: RE: [LARTC] multipath routing
From: [EMAIL PROTECTED] on behalf of Edmundo Carmona
Sent: Thu 10/27/2005 8:20 AM
To: lartc
Subject: Re: [LARTC] multipath routing
Multipath takes a little more that just setting the default
route. You
have to set separate routing tables for each interface involved in
the
multipath routing (though I haven't understood yet why they
are
needed.. the fact is that if you don't set them, multipath
won't
route).
Also, even if you set it all right, it doesn't mean that
if you send
two packets to a location X, one will go through one interface
and the
second will go through the other. Routes are cached, and after
a
routing decision has been made for the first packet, packets going
to
that same host will go through the same interface till the caching
time
has gone by.
On 10/26/05, comp.techs <[EMAIL PROTECTED]>
wrote:
> Hi, I am tring to us ip route to load balance between two
interfaces.
>
>
>
> ip route add equalize 10.200.1.0/24
nexthop via 10.200.0.2 dev neta nexthop
> via 10.200.0.2 dev
neta2
>
> Where neta and neta2 are gre tunnels. Testing
show that packets travel in
> a single sided manner.
>
>
Do I need to use the multipath (IP_ROUTE_MULTIPATH_CACHED)
module?
>
> thx jason
>
_______________________________________________
> LARTC mailing
list
> LARTC@mailman.ds9a.nl
> http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
>
>
>
_______________________________________________
LARTC
mailing list
LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
_______________________________________________ LARTC mailing list LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
