Raj, I use something just like you make and for this problem I have patched my kernel with diff-routes patch (there is a link in LARTC) and I have make a little script that makes just a ping to an outside address every 5 min (cron job) and flush the route cache after this ping, like this:
ip route flush cache So all cache will be lost (off course that conections that still exists will remain with their track to the destination). Att, Nataniel Klug ----- Original Message ----- From: "Raj Mathur" <[EMAIL PROTECTED]> To: <lartc@mailman.ds9a.nl> Sent: Thursday, February 23, 2006 4:14 PM Subject: [LARTC] Balancing multiple connections and NAT > Hi, > > I have a client connected to the 'net through 3 ISP's. Have set up a > Linux box to do routing and load sharing for the 3 connections. A > fourth interface is connected to the LAN with private IP addresses. > Am using iptables to SNAT traffic to the appropriate IP depending on > the interface the packet gets routed onto. The setup looks something > like this: > > Interface IP Gateway Table Network > --------- -- ------- ----- ------- > intA ipA gwA tableA netA > intB ipB gwB tableB netB > intC ipC gwC tableC netC > [intD is the LAN interface] > intD ipD (private) no gateway global netD > > This works fine most of the time, except that once in a while (every > 5-10 minutes or so) packets going out on (e.g.) intB suddenly start > getting NAT'ed to source address ipA (i.e. the address of another > interface). Obviously this plays hell with the existing connections > on that link! > > The ip commands I'm using are: > > /sbin/ip route add netA dev intA src ipA table tableA > /sbin/ip route add netA dev intA src ipA > /sbin/ip route add default via gwA table tableA > /sbin/ip route add netB dev intB src ipB table tableB > /sbin/ip route add netB dev intB src ipB > /sbin/ip route add default via gwB table tableB > /sbin/ip route add netC dev intC src ipC table tableC > /sbin/ip route add netC dev intC src ipC > /sbin/ip route add default via gwC table tableC > /sbin/ip route add default scope global nexthop via gwB dev intB weight 1 nexthop via gwC dev intC weight 2 nexthop via gwA dev intA weight 2 > /sbin/ip rule add from ipA table tableA > /sbin/ip rule add from ipB table tableB > /sbin/ip rule add from ipC table tableC > > The iptables commands are: > > /sbin/iptables -P FORWARD DROP > # Enable full flow on the LAN > /sbin/iptables -I FORWARD -s netD -i intD -j ACCEPT > /sbin/iptables -I FORWARD -d netD -o intD -j ACCEPT > # Allow all packets to go out > /sbin/iptables -I OUTPUT -o intA -j ACCEPT > /sbin/iptables -I OUTPUT -o intB -j ACCEPT > /sbin/iptables -I OUTPUT -o intC -j ACCEPT > /sbin/iptables -I OUTPUT -o intD -j ACCEPT > /sbin/iptables -I INPUT -i intD -j ACCEPT > /sbin/iptables -I INPUT -i lo -j ACCEPT > /sbin/iptables -P INPUT DROP > /sbin/iptables -A INPUT -i ! intD -m state --state RELATED,ESTABLISHED -j ACCEPT > # Hmmm, why is this one there? > /sbin/iptables -A INPUT -i intD -m state --state RELATED,ESTABLISHED -j ACCEPT > # NAT depending on outbound interface > /sbin/iptables -t nat -A POSTROUTING -s netD -o intA -j SNAT --to-source ipA > /sbin/iptables -t nat -A POSTROUTING -s netD -o intB -j SNAT --to-source ipB > /sbin/iptables -t nat -A POSTROUTING -s netD -o intC -j SNAT --to-source ipC > > Any idea why connections that are flowing perfectly would suddenly > decide to start getting NAT'ed to the wrong source? Or some place on > the 'net I can start looking? > > Regards, > > -- Raju > -- > Raj Mathur [EMAIL PROTECTED] http://kandalaya.org/ > GPG: 78D4 FC67 367F 40E2 0DD5 0FEF C968 D0EF CC68 D17F > It is the mind that moves > _______________________________________________ > LARTC mailing list > LARTC@mailman.ds9a.nl > http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc _______________________________________________ LARTC mailing list LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
