Ok,
After much research and e-mails to the list, I'm finally to the point
where I have filtering setup properly.
Now, I'm trying to figure out tc filter so that I can classify packets
on both eth0 and eth1.
So, lets take for example Samba traffic. I want to be sure that its
being sent with relative speed so that my shares don't get lagged. And
what the heck, its as good a place as any to start.
While I understand how to get the protocol number out of the header, I
am having difficulty getting the rest of the field. Mostly, it has to do
with offsets and which uX to use.
So, going off of what I think is correct, I have come up with this:
tc filter add dev eth1 parent 2: protocol ip prio 10 u32 match ip
protocol 6 match u32 0xff534d42 0xffffffff at nexthdr+23 flowid 2:50
I seriously doubt this is the proper way to match a Samba header.
So my question is this. How do I identify where the offset is for a
given header? I assume that (going off the LARTC How To) I can look at
output from wireshark and simply count to the field I am after. (This is
how I figured out that tc filter add dev ppp14 parent 1:0 prio 10 u32
match ip protocol 6 0xff match u8 0x10 0xff at nexthdr+13 flowid X:Y
uses next header+13 to go from the protocol field to the ACK bit for the
flags.)
The thing is. When I run this rule, none of the Samba traffic is being
routed to 2:50... so obviously I'm not going something right.
Thanks for your help,
Vadtec
_______________________________________________
LARTC mailing list
LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc