Hi guys,
Just installed Bearing 1.0-RC3
Running a Static ADSL via eth1 and Cable Modem pppoe via eth0
For some reason, when I was testing, without the ADSL, my cable
connection seemed to work pretty fine, once the both of them was
configured, then the PPPOE seems like he didn't want to start up, I
received the following messages:
Jun 24 17:10:45 gw-homenet pppd[25591]: Connecting PPPoE socket:
00:00:00:00:00:00 0000 0x807c260
Jun 24 17:10:45 gw-homenet pppd[25591]: Couldn't get channel number:
Transport endpoint is not connected
Jun 24 17:10:45 gw-homenet pppd[25591]: Doing disconnect
Jun 24 17:11:15 gw-homenet pppd[25591]: Sending PADI
Thnks for any experienced help that will follow,
Please see config below:
--- Interfaces setup ---
auto lo ppp0 eth1 eth2 eth3
iface lo inet loopback
# Cable interface (ppp0)
iface ppp0 inet ppp
pre-up ip link set eth0 up
provider dsl-provider eth0
# ADSL Interface (eth1)
iface eth1 inet static
address 10.0.0.100
masklen 24
broadcast 10.255.255.255
gateway 10.0.0.138
# LAN Interface-Backbone (eth2)
iface eth2 inet static
address 192.168.10.254
masklen 24
broadcast 192.168.10.255
# LAN Interface-Clients (eth3)
iface eth3 inet static
address 192.168.1.1
masklen 30
broadcast 192.168.1.3
PPPOE/PPP Configurations:
These are the standard configs that came with Bearing, besides the
change of the PAP login name in pap, and PPPOE config
And this:
Shorewall Config
Zones:
#ZONE DISPLAY COMMENTS
net Net Internet
loc Local Local networks
loc1 Subnet 1.0 Local Subnet
loc2 Subnet 11.0 Local Subnet
Interfaces:
########################################################################
######
#ZONE INTERFACE BROADCAST OPTIONS
net eth1 detect routefilter
net ppp0 - routefilter,norfc1918
loc eth2 detect routestopped
- eth3 detect routestopped
Hosts
#ZONE HOST(S) OPTIONS
loc1 eth3:192.168.1.0/30 routestopped
loc2 eth3:192.168.11.0/28 routestopped
Policy:
########################################################################
#######
#SOURCE DEST POLICY LOG LEVEL
LIMIT:BURST
loc net ACCEPT
loc1 net ACCEPT
loc2 net ACCEPT
$FW loc ACCEPT
#fw net ACCEPT
net all DROP info
10/sec:40
all all REJECT info
Masq:
########################################################################
######
#INTERFACE SUBNET ADDRESS
ppp0 eth2
ppp0 192.168.11.0/28
ppp0 192.168.1.0/30
eth1 eth2
eth1 192.168.11.0/28
eth1 192.168.1.0/30
-------------------------------------------------------
Sponsored by:
ThinkGeek at http://www.ThinkGeek.com/
------------------------------------------------------------------------
leaf-user mailing list: [EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-user
SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
