[EMAIL PROTECTED] wrote about "[leaf-user] wisp-dist img / build 2312 --- can't get AP mode to pass traffic over TT 100mW cards":
> wisp-dist build 2312 > > I have loaded the 2312 flash image on the new TT board and also on the Soekris > board. I am using the new 100mW higher power card. > > They pass traffic in infrastructure / client mode but not in AP mode. If I use >station- > server or TT firmware for AP, the wisp-dist client works but not in AP mode. I noticed that only one of the antenna sockets works in TT's high power cards, at least in Access Point (Master) mode. This may be your problem as well. Let me know. > > I have seen it mentioned it may have something to do with the new pcmcia controller > on these two boards. I am not sure. 2312 should support PCMCIA controllers on both new TT and Soekris out of the box. > Also, the RSSI reading in client mode just sits at 100% whether connected or not. I > figure this is a problem with the driver talking to the card. Well, TT's high power cards are strange in the way they report values. I never ran TT's high power in client mode (yet), however, in AP mode I see that TX power level that it reports is endlessly jumping from high to low. It doesn't affect operation in any other way, though. Nevertheless, client statistics are reported correctly when the card is in AP mode. -- Best Regards, Vladimir Systems Engineer (RHCE) ------------------------------------------------------- This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE! https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390 ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
