I have a Dachstein LRP with this routing table:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.50.50.0 68.2.2.1 255.255.255.0 UG 0 0
0 ipsec0
192.168.38.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
68.2.2.0 0.0.0.0 255.255.255.0 U 0 0
0 eth0
68.2.2.0 0.0.0.0 255.255.252.0 U 0 0
0 ipsec0
0.0.0.0 68.2.2.1 0.0.0.0 UG 0 0 0 eth0
The subnet 10.50.50.0/24 on the right-hand side of the IPSec tunnel has a
hub router at 10.50.50.1 that has routes to the other VPN subnets. My '38
network is one of the spokes of a hub & spoke topology.
I'd like to add a single static route here (left-hand side, spoke end) and
be able to reach the far-flung spoke networks via the hub router at
10.50.50.1 (e.g., those up-state wahoos over on the 192.168.4.0/24
spoke). So I tried:
# route add -net 192.168.0.0 netmask 255.255.0.0 gw 10.50.50.1
SIOCADDRT: Network is unreachable
Unfortunately, I cannot ping hosts in 10.50.50.0/24 from the LRP, although
I can ping any host in 10.50.50.0/24 from another host in my '38 network.
How might I be able to configure my spoke, and the other spokes, to use the
hub router?
- Bill
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
------------------------------------------------------------------------
leaf-user mailing list: [EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-user
SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
