Hi,
I am testing Bering 2.3.1 with a multiple IP interface as:
# ip addr show eth0
5: eth0: <BROADCAST,MULTICAST,ALLMULTI,UP> mtu 1500 qdisc pfifo_fast qlen
1000
link/ether fe:fd:58:24:f8:e6 brd ff:ff:ff:ff:ff:ff
inet 82.46.148.130/24 brd 82.46.148.255 scope global eth0
inet 82.46.148.128/24 scope global secondary eth0
inet6 fe80::fcfd:58ff:fe24:f8e6/64 scope link
Using the included ipsec.lrp (v.1.0.9) I setup VPN with:
# /etc/ipsec.conf
[...]
interfaces="ipsec0=eth0 ipsec1=eth0:0"
[...]
After "/etc/init.d/ipsec restart" the following messages is printed:
Device "eth0:0" does not exist.
ipsec_setup: unable to determine address of `eth0:0'
This messages is printed also if I change the ip address with the
following command:
ip addr add 82.46.148.128/24 dev eth0 label eth0:0
I have read in
http://www.freeswan.ca/docs/HA/HA_VPNS_With_FreeSWAN.html
that this interface specification is correct. This is possible
only in v2 release (Bering v2.4) ?
Thank you for any suggestions.
Regards,
Sandro Doro
--
Sandro Doro
e-mail: sandro.doro AT istruzione.it
-------------------------------------------------------
This SF.net email is sponsored by: Splunk Inc. Do you grep through log files
for problems? Stop! Download the new AJAX search engine that makes
searching your log files as easy as surfing the web. DOWNLOAD SPLUNK!
http://sel.as-us.falkag.net/sel?cmd=lnk&kid=103432&bid=230486&dat=121642
------------------------------------------------------------------------
leaf-user mailing list: [email protected]
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/
