Hi Friends --
On Bering uClibc 3.1, is there a way to control which network card gets
assigned eth0, eth1, etc. when all cards use the same module? I have two
on-board NICs and a card NIC in the same system, and the card is detected first
(assigned eth0), with the on-board NICs last (assigned eth1 and eth2). I would
prefer to use the onboard NICs as eth0 and eth1.
The last time I could find this question asked was 2003 -- the answer then was
no -- so I was wondering if anything had changed since then?
Thanks so much!
Merrick
_________________________________________________________________
Helping your favorite cause is as easy as instant messaging. You IM, we give.
http://im.live.com/Messenger/IM/Home/?source=text_hotmail_join
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
------------------------------------------------------------------------
leaf-user mailing list: leaf-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/
