Hi, can anybody point me where to look at because I'm running out of ideas with my bond setup?
I have a test b-u 3.1 system with two physical network interfaces (100 Mbps and GbE). I load bonding miimon=100 mode=1, then vlan tagging driver 8021q and after that network card drivers. bond0 is brought up with simple iface definition in interfaces plus a slaves line. A neighboring systems runs ping -r to the ip of the bond interface and after command ifup bond0 is run, pings flow nicely. But when I add first vlan-interface onto bond0, pings stop. tcpdump shows no traffic either. Nothing more than command "vconfig add bond0 600" is needed, no "ip link set bond0.600 up" or such is needed. Traffic on the vlan interface flows nicely, but the untagged bond0 interface dies. I have a similar bond setup running fine on a Debian box with latest and greatest kernel, but I highly doubt that I'm just missing something on Bering uClibc. Best regards, Erkki ------------------------------------------------------------------------- This SF.net email is sponsored by the 2008 JavaOne(SM) Conference Don't miss this year's exciting event. There's still time to save $100. Use priority code J8TL2D2. http://ad.doubleclick.net/clk;198757673;13503038;p?http://java.sun.com/javaone ------------------------------------------------------------------------ leaf-user mailing list: leaf-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/leaf-user Support Request -- http://leaf-project.org/